•
Make sure all Neumann DSP devices are connected to the same router or switch.
•
Be sure all DSP devices are switched on.
•
Ensure that the Neumann DSP devices are not in standby mode. If they are play some audio
to wake them up.
•
Switch the Neumann DSP devices off and on and wait for 60 seconds (180 s for KH 750
AES67).
•
Check if IPV6 is enabled at router and PC/MAC
•
Perform a factory reset (see below).
Factory reset for the KH 80 DSP
To reset the KH 80 DSP internal controls to their factory default values:
•
Switch on the KH 80 DSP.
•
While the logo is still red indicating boot up move the SETTINGS switch up and down
repeatedly until a few seconds after it turned white.
Automatic (default): The subwoofer automatically chooses between analog or digital (AES3)
input signals. Digital signals have priority over analog signals.
The logo will then start flutter flash red for a few seconds before reverting to white.
Factory reset for the KH 750
To reset the KH 750 internal controls to their factory default values:
•
Switch on the KH 750.
•
While the power light is solid red during the boot up phase, move the STANDBY switch up
and down repeatedly until a few seconds after it turned green.
The power light will then flash red while the default settings are being applied before reverting
to green.
MA 1 – Automatic Monitor Alignment | 10