Download Print this page
Courtyard Creations RTS493V Assembly Instructions Manual

Courtyard Creations RTS493V Assembly Instructions Manual

Advertisement

Quick Links

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
Use the correct bolts as indicated. Do not tighten any of the bolts until the swing is completely assembled.
!
Do not discard of any of the packaging until you have checked that you have all of the parts and
!
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
!
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC NO. When contacting the service center.
!
INTENDED FOR RESIDENTIAL USE ONLY.
RTS493V
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DON'T RETURN TO STORE!
STOP
PAGE 1 OF 6
COURTYARD CREATIONS INC.

Advertisement

loading
Need help?

Need help?

Do you have a question about the RTS493V and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Courtyard Creations RTS493V

  • Page 1 Children should always be under direct adult supervision while using this product. Retain these assembly instructions for future reference. Quote the following FQC NO. When contacting the service center. SERVICE CENTER TOLL FREE NO. TEL: 1-877-539-7436 FAX: 1-877-539-7439 DON’T RETURN TO STORE! STOP COURTYARD CREATIONS INC. PAGE 1 OF 6...
  • Page 2: Parts List

    C. Lay out all parts on a flat surface and identify them using the table below. PARTS LIST PART PART MATERIAL CODE PART Q’TY MATERIAL CODE PART Q’TY RTS493V-CS09-8 17C17A1306001Y4 TOP CROSS BEAM W/ADJUSTABLE TEETH SCREW ST4.2*16 62RUS4040N201 17FA08060601-Y4 REAR UPRIGHT SUPPORT WASHER d8.5*D17*1.6 62RUS4040N101...
  • Page 3 Assembly(Note: For all nut and bolt fastening, always use a washer (#16 and #17) between the tube and bolt Step 2 Step 1 or the tube and nut). Step 1: Attach the front and rear upright supports (#2 and #3) at the top by using bolts (#11), Do not tighten bolts washers (#16) and plastic nuts (#19).
  • Page 4 Step 6: Fasten another seat and back support brace (#6) to the back of two seat assemblies (#7) by using bolts (#14) and Back washers (#17). See Fig. C. Back Note: Make sure the two arcs of the seat and back support brace (#6) should be facing outside.
  • Page 5 Step 9: Hook the suspension spring (#22) to the top of the swing arm tubes (#10) and do the same for the other side. See Fig. G. Fig. G Step 10: Hang the other side of suspension spring (#22) into the hole of each side on the angled braces of the top cross beam w/adjustable teeth (#1).
  • Page 6 Step 12: Attach and fasten the canopy assembly onto the adjustable teeth on top cross beam w/adjustable teeth (#1) with plastic screws (#24) to each side of canopy/frame connectors (#23). See Fig. J and Fig. K. Fig. J Step 13: To assure stability, double check that all of the bolts have been completely tightened and cover them with bolt caps...