Advertisement
Quick Links
ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
Use the correct bolts as indicated. Do not tighten any of the bolts until the swing is completely assembled.
!
Do not discard of any of the packaging until you have checked that you have all of the parts and
!
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
!
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC NO. when contacting the service center.
!
E-2
INTENDED FOR RESIDENTIAL USE ONLY.
RTS493C
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
PAGE 1 OF 5
COURTYARD CREATIONS INC.
Advertisement
Related Manuals for Courtyard Creations RTS493C
Summary of Contents for Courtyard Creations RTS493C
- Page 1 Children should always be under direct adult supervision while using this product. Retain these assembly instructions for future reference. Quote the following FQC NO. when contacting the service center. SERVICE CENTER TOLL FREE NO. TEL: 1-877-539-7436 FAX: 1-877-539-7439 COURTYARD CREATIONS INC. PAGE 1 OF 5...
-
Page 2: Phillips Screwdriver
- Hex. Key Wrench (See Part #22 and #23) C. Lay out all parts and identify using the table below. PARTS LIST PART MATERIAL PART Q’TY 17C17A1306001YX CODE SCREW ST4.2*16 RTS493C-CS09-8 17FA08060601-YX WASHER d8.5*D17*1.6 62RUS4040N101 17FA05050401-YX FRONT UPRIGHT SUPPORT WASHER d6.5*D16*1.2 62RUS4040N201 18000C06001 REAR UPRIGHT SUPPORT PLASTIC NUT M8*P1.25... - Page 3 Note: When fastening with bolts and nuts, always use a washer (#14 and #15) between the tube and the bolt and the tube and the nut. Step 2 Step 1: Fasten the front and rear upright support (#2 Step 1 and #3) at the top, by using bolts (#9), washers (#14), and plastic nuts (#16).
- Page 4 Step 6: Hook the suspension springs (#18) into the top of both swing arm tubes (#8). Do the same procedure for both sides. See Fig. C. Fig. C Step 7: Hang the opposite ends of the suspension springs (#18) into the holes located on the angled braces of the top cross beam w/adjustable teeth (#1).
-
Page 5: Warranty
Fig. G Warranty • This product is covered by Courtyard Creations Inc.'s one–year limited warranty. • Proof of purchase (dated register receipt) is required for warranty claims. • It remains the customer’s responsibility for freight and packing charges to and from the service center.
Need help?
Do you have a question about the RTS493C and is the answer not in the manual?
Questions and answers