Advertisement
Quick Links
ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
Use the correct bolts as indicated. Do not tighten any of the bolts until the swing is completely assembled.
!
Do not discard of any of the packaging until you have checked that you have all of the parts and
!
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
!
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC NO. When contacting the service center.
!
INTENDED FOR RESIDENTIAL USE ONLY.
RTS493F
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DON'T RETURN TO STORE!
STOP
PAGE 1 OF 6
-WM
COURTYARD CREATIONS INC.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Courtyard Creations RTS493F-WM
Summary of Contents for Courtyard Creations RTS493F-WM
- Page 1 Children should always be under direct adult supervision while using this product. Retain these assembly instructions for future reference. Quote the following FQC NO. When contacting the service center. SERVICE CENTER TOLL FREE NO. TEL: 1-877-539-7436 FAX: 1-877-539-7439 DON’T RETURN TO STORE! STOP COURTYARD CREATIONS INC. PAGE 1 OF 6...
-
Page 2: Parts List
A. Read instructions thoroughly. Acquaint yourself with the inventory of parts and the accompanying drawings to ensure safe and proper assembly. B. You will need the following tools - Phillips Screwdriver - Nut Wrench (See Part #28) - Hex.Key Wrench (See Part #27) C. - Page 3 Aaaembly(Note: For all nut and bolt fastening, always use a washer (#18 and #19) between the tube and bolt or the tube and Step 1 Step 2 nut). Step 1: Attach the front and rear upright supports (#2 and #3) at the top by using bolts (#13), Do not tighten bolts washers (#18) and plastic nuts (#21).
- Page 4 Step 6: Fasten another seat and back support brace (#6) to the back of two seat assemblies (#7) by using bolts (#16) and washers (#19). See Fig. C. Note: Make sure the two arcs of the seat and back support brace (#6) should be facing outside.
- Page 5 Step 9: Hook the suspension spring (#22) to the top of the swing arm tubes (#10), and do the same for the other side. See Fig. G. Fig. G Step 10: Hang the other side of suspension spring (#22) into the hole of each side on the angled braces of the top cross beam w/adjustable teeth (#1).
- Page 6 Step 15: Attach and fasten the canopy assembly onto the adjustable teeth on top cross beam W/adjustable teeth (#1) with plastic screws (#24) to each side of canopy/frame connectors (#23). See Fig. J and Fig. K. Fig. J Step 16: Re-check and re-tighten all of the plastic nuts and bolts to assure stability.
Need help?
Do you have a question about the RTS493F-WM and is the answer not in the manual?
Questions and answers