OML Microstim2 Instruction Manual page 16

Key Features
Controls & Indicators
The stimulation output level controls
are the rotary knobs. To switch ON
the stimulator, rotate either of the
level controls clockwise from the 'I/0'
position until a click is heard. The
stimulator should emit a short bleep
and the green power indicator will
begin flashing and continue flashing
while the stimulator remains on.
After the initial long beep a sequence
of quick beeps will signal the number
of the mode selected. Note that
mode 0 means there will be zero short
beeps! Further clockwise rotation
of the level controls increases the
stimulation intensity. To switch OFF
the stimulator, rotate both level
3
controls fully anti-clockwise until a
click is heard and the power indicator
is extinguished.
The presence of a stimulation voltage
at either of the output connectors is
shown by the corresponding yellow
output indicator. The 'A' output is on
the left of the box and the 'B' output
is on the right.
The mode select control is the central
pushbutton switch. A number is
displayed which indicates the mode
selected. To increase the mode the lower switch is pressed and to decrease the
upper switch is pressed. The mode control permits selection of the appropriate
stimulation frequency and pattern for the chosen exercise.
16