How To Disassemble And Assemble; Handle Removal - LG LSXC22396S Service Manual

How to disassemble and assemble

1. DOOR
1) Disconnect water supply tube 2 in the lower part of
freezer door.
Pull the water supply tube forward while pressing on the
coupling 1 as shown in the drawing.
Disconnecting the tube under the door caused about
3 pints(1.5 litters) of water to flow out. Use a big
container to catch it.
Note: Connect the same tube color
2) Remove the freezer door.
(1) Loosen hinge cover screw of freezer door and remove the
cover.
Disconnect all connecting lines except grounding cord.
Hinge Cover
2) Turn hinge lever in arrow A direction until it is loosened and
take it out in arrow B direction.
Hinge Lever
Note : • When disconnecting refrigerator door, turn hinge lever
counterclockwise.
• If the hinge or bracket are bent during assembly, use
two extra screws (Tap Tite M6, Left Hinge attaching
screw) in the holes of the upper hinge.
(3) Disconnect upper hinge 1 from the hinge supporter 2 by
grasping the front part of upper hinge and lifting up (Hinge
Assembly,U) in arrow A direction and pull foward in arrow B
direction. Be careful because the door may fall, damaging the
door, the floor, or injuring you.
Connecting
Line
Earthing
Cora
(4) Lift up the freezer door 1 in arrow direction and disconnect
the door from the lower hinge 2 . Don't pull the door forward.
Note : Lift up the freezer door until the water supply tube Is fully
taken out.
(5) Assembly is the reverse order of disassembly.
2. HANDLE

1) HANDLE REMOVAL

To move the refrigerator through a house door, it may be
necessary to remove the refrigerator door handles.
Note : Handle appearance may vary from illustrations on this
page.
Loosen the set screws with a 2.5mm(3/32") Allen wrench and
remove the handle.
Note : If the handle mounting fasteners need to be tightened or
removed, use a 1/4" Allen wrench.
Place the handle on the door by aligning handle footprints to fit
mounting fasteners and tighten the set screws with a
2.5mm(3/32 ) Allen wrench.
2) HANDLE REINSTALLATION
Note : If the handle mounting fasteners need to be tightened or
removed, use a 1/4" Allen wrench.
Copyright © 2017 LG Electronics Inc. All rights
reserved. Only training and service purposes.
82