Advertisement
CD-RW2000 — Additional features
6
Indicating and changing the
TRIM value
The trim values, used in synchronized recording and
track division (4.5, "Rehearsal" in the manual) can
now be viewed and set independently outside the
rehearsal modes using two new menus.
Previously these two values were identical, and could
only be set in rehearsal mode.
These menu items are
Sync_TXXXXf
Inc_TXXXXf
.
The maximum and values for these parameters
remain the same as previously (±125 frames on either
side of the original point, at 75 frames/second).
TEAC CORPORATION
Phone: (0422) 52-5082
7
Meter peak hold time
A new menu item has been added to allow the meter
peak hold time to a chosen value. Previously this was
preset to 1.2 seconds and could not be changed.
The new menu allows peak hold settings of between
0.0 seconds and 2.5 seconds. There is also a
setting, where peak readings are displayed and held
until the
MULTI DIAL
key of the remote control unit is pressed.
ENTER
and
8
New media types
The TASCAM CD-RW2000 now supports High
Speed CD-RW (4x to 10x) in addition to Multi Speed
CD-RW (1x to 4x) media.
9
Finalization and erase times
The time taken to perform finalization and erase
operations depends on the media used, as listed here:
• Finalization:
CD-R media
Multi Speed CD-RW 4x
High Speed CD-RW 8x
• Erasing discs:
Multi Speed CD-RW 4x
High Speed CD-RW 8x
3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan
control is pressed or the
8x
Printed in China
HOLD
Advertisement
