Advertisement
alternate between reverse cycle heat mode and
electric heater mode according to the difference
between the setting temperature and the room
temperature.
The fan motor cycles when the compressor stops.
The reverse cycle and electric heater can not be run at
the same time. In following cases, it is normal that the
reverse cycle does not operate.
- FAN:Fan operation only without heating and cooling.
Note: If the unit has DIP SWITCHES, the temperature
ange s controlled by DIP SWITCHES.
See DIP SWITCHES CONFIGURATIONS on pag
or details.
setting is
or heating mode.The temperature can be set in
for 3 seconds to alternate the temperature display
and
In cooling mode, press the button to turn the constant
fan function on or off. When the function is turned on,
the constant fan light will illuminate, identifying the fan
is running continuously for cooling. When the function
is turnd off, the constant fan light will go out, identifying
the fan cycle runs with compressor stop.
NOTE: Every time the unit is turned on, the function
Pads on the control panel are not available.The
unit can be set by using wire controller only.
are not available. The unit can be set by
Advertisement
