Advertisement
Dip switch controls are located behind front panel,
through an opening below the control panel.To
access,remove front panel.See Fig.2.
Dip switches are accessible without opening the
control box.See Fig.3.
Unit must be powered OFF to effectively change
their status.
See Table 1 and Fig.4 for dip switch configurations
and functions of each dip switch position.
control panel are not available.The unit can be set
by using wire cotroller only
accessory on the control panel.
operation after 3 seconds when any button is
pressed.
NOTE: When there are wide differences between
USERS MANUAL and Remote Control Illustration
on function description, the description on USERS
MANUAL shall prevail.
(Pads on the
). ou can install the
Y
Advertisement
