Table of Contents
Advertisement
Tour speed
4 Motion Detection Tour Program
Configure the motion detection feature.
Setting
No. 1 - No.
Area Number
Dwell Time
Dwell Time After
Detection
Detection Sensi-
tivity
(high 1 - low 10)
Motion Detection
Window
Configuring the Camera and Image Settings
Speed at which modes are switched. The
larger the numeric value, the faster the speed.
Specify the area number for the [Motion Detec-
tion Tour] in Mode Setting. The areas that can
be specified are as follows.
1
[Example] When the area settings are as fol-
lows: No. 1 = 1, No. 2 = 2, No. 3 = 3, and No. 4
= 4, the display order is No. 1 → No. 2 → No.
3 → No. 4 → No. 1 →..., and the order of area
display is the setting that was entered (→ page
12), 1 → 2 → 3 → 4 → 1...
Set the maximum number of tour user area.
Time required when switching areas. The
smaller the numeric value, the faster the speed.
When a moving object is detected in an area,
the view switches to display the image in that
area for the duration specified here.
Set the sensitivity of motion detection. Decreas-
ing the numeric value increases the sensitivity,
and increasing the numeric value decreases
the sensitivity.
Note:
•
If you set this numeric value too low, the
sensitivity may increase too much and lead
to more false detections.
Set whether or not to display a frame around
the subject when a motion is detected.
Details
x1 - x10
Range of Values
1 -
-
x1 - x10
1s - 10s
Level 1 - Level 10
ON, OFF
15
Advertisement
Chapters
Table of Contents
