Tamron 180-View 180NT-P-CM Owner's Manual page 29

Starting the Software
Turn on the power for the camera that is connected to the computer.
1. Double-click on the "130NT-P-CM Parameter Setting Ver1.0.exe"
icon that you copied onto your computer.
A window for selecting the COM port appears.
2. Select the COM port connected to this computer, and click [OK].
Select a
COM port
The main configuration window appears.
Checking the COM Port to Use
■
1 Right-click on [My Computer] and select [Properties].
2 In the [System Properties] window, select [Hardware] → [Device Manager].
3 In the [Device Manager] window, verify that "Silicon Labs CP 11x USB to
UART Bridge (COMxx)" is displayed under [Ports (COM & LPT)].
The COM port [comxx] can be used.
Caution
Make sure that the port in the Parameter Setting window match-
es with the computer.
If there is a mismatch, you will not be able to control the camera.
Starting the Software
Selecting [ON] will display the
latest settings saved in the
camera. (Initial settings will be
shown on the first run.)
Click
Saves the current settings
to the camera's EEPROM.