Before Setting Up
Connecting the Camera to the Computer
Start up the computer, and connect the camera to the computer with a
USB cable.Then turn on the power for the camera.
To the USB port
of the unit
Use caution not to pull on the the rubber cap on the USB port too much,
as it will completely detach. In addition, to maintain its water and dust re-
sistance, always reattach the rubber cap when the camera after use, and
check that it is flat on the main unit without any of it sticking out.
Operational Environment
Please check if your computer meets the requirements below:
Item
Operating System
RAM
Hard Disk Space
Motion-Detecting Alarm
■
The alarm turns on when a moving subject is detected. The alarm output
uses an NPN open collector output. Please use the alarm at a drive ca-
pability that is less than its maximum, 50 mA at DC 12V.
Data output
* Please supply your own USB cable.
Windows XP Professional Version 2002 SP2/SP3, Windows Vista
56MB or more
1GB or more
USB cable
Operational Environment
Before Setting Up