Starting The Software; Creating A Backup File; Loading A Backup File - Tamron 180-View 180NT-P-CM Owner's Manual

To Exit the Software
1. From the menu, select [Action (A)] → Write to [EEPROM (W)].
The settings displayed in the main configuration window are written to the EE-
PROM of the camera.
When the write process is complete, "Successfully Loaded" is displayed on the
dialog box. Click [OK] to close the dialog box.
Note:
Performing a [Write to EEPROM] will overwrite the initial settings with the current settings.
When performing a [Write to EEPROM], acquire the latest camera settings using [Reload (R)].
(The COM port must to be set. For setting the COM port, see "Checking the COM Port
to Use" (page 9).)
2. Click on the
If the message "Save to EEPROM?" appears, this means that the settings
have not been written yet. Click [Yes].
When the write process is complete, "Successfully Loaded" is displayed on the
dialog box. Click [OK] to close the dialog box.
The "130NT-P-CM Parameter Setting Ver1.0.exe" closes and finishes the con-
figuration.
Creating a Backup File
1. From the menu, select [File (F)] → [Save file (S)].
The settings displayed in the main configuration window are exported and
saved to a file.
Loading a Backup File
1. From the menu, select [File (F)] → [Open file (O)].
2. Select the backup file to load, and click [Open].
The settings are reflected in the main configuration window, and the settings
are also updated in the camera.
Note:
Do not load any file created by any other procedure than that described here.
on the top right of the main configuration window.

Starting the Software

11