Advertisement
TROUBLES
1. UNIT DOES NOT
START WHEN
PRESSING 1/0 BUTTON
2. NOT COOL ENOUGH
3. POWER SHUT OFF AT
HEATING MODE
4. NOISY OR VIBRATION
5. GURGLING SOUND
8
TROUBLE SHOOTING
POSSIBLE CAUSES
- Water full indicator blinks, water tank
is full.
- Room temperature is higher than
the set temperature.(Heating mode)
- Room temperature is lower than
the set temperature.(Cooling mode)
- The windows or doors in the room
are not closed.
- There are heat sources inside the
room.
- Exhaust air duct is not connected or
blocked.
- Temperature setting is too high.
- Air filter is blocked by dust.
- The automatic over heat protection
function. When the temperature at
O
the air outlet exceed 70 C/158 F,the
device will stop.
- The ground is not level or not flat
enough.
- The sound comes from the flowing
of the refrigerant inside the
air-conditioner.
SUGGEST REMEDIES
Dump the water in the water tank.
Reset the temperature.
Reset the temperature.
Make sure all the windows and
doors are closed.
Remove the heat sources if possible.
Connect the duct and make
sure it can function properly.
Decrease the set temperature.
Clean the air filter.
Switch on again after the unit has cool down.
O
Place the unit on a flat, level
ground if possible.
It is normal.
Hide quick links:
Advertisement
