Generate Dual Out Sounds For Cross-Saber; Format Micro Sd - Naigon's Electronic Creations Spark 3 R2 Setup Manual

5.6.

GENERATE DUAL OUT SOUNDS FOR CROSS-SABER

The best experience for Cross-Saber is to utilize the new dual out sounds, named DOUTNN.WAV, where NN is a
number 01 to 99. Basically, these files would be a second extension mixed in the original at the delay of humStart
in the config, which would make a second delayed sound when the second blades turn on. Creating these manually
would be a tedious task. However, with the new Create Dual Out Wavs function in the config editor, it is a breeze.
For each font you just open the font, go to Edit->Create Dual Out Wavs, and click. That's it; one dual out wav will
be created for each out wav for the font, with the secondary extension mixed at the delay of humStart set in the
config.
Once created, just save the font so the number is updated any the font will now use the dual out sounds if Cross-
Saber is enabled. Note that if there are no dual out sounds the normal out ones will be used so this is not a
mandatory step, but does enhance the overall experience.
5.7.

FORMAT MICRO SD

I no longer recommend using Windows built-in format tool to format the SD cards, as it doesn't do a true UNIX
style format. Instead, it is much better to use a good 3
https://www.sdcard.org/downloads/formatter_4/
This tool will properly format the SD card for use with all my boards.
Upon launching the tool the window below will be shown
rd
party tool, such as SDFormatter.
Page | 35