Flash Wiring - Naigon's Electronic Creations Spark 3 R2 Setup Manual

Figure 2 – Basic wiring for Spark 3™. This will drive a single main LED and would require a removable battery for charging. Note that a
resistor between the blue wire and C1- of TruDrive™ would be needed if the LED is red, amber, or red-orange.
4.2.

FLASH WIRING

Wiring a basic setup to have a TriCree LED with two die of one color and a third die for a flash color is a popular
choice for Spark 3™. This setup allows for a bright single-color blade while still allowing for an effect/aux color for
blast and clash/lockup effects. The wiring diagram below shows how to utilize that setup.
The preferred LED to use for this setup is the TriCree, as it has an optic made specifically for this configuration, and
it has a great balance of brightness with good efficiency, so it doesn't waste too much power. It also produces a
very even blade when diffused and sanded. The X2/X4 previously recommended is no longer preferred as it's optic
doesn't allow enough of the brightness down the tube evenly.
Page | 10