Single Av Switch Wiring - Naigon's Electronic Creations Spark 3 R2 Setup Manual

Figure 4 – RGrB wiring utilizing the NECree RGB v2 LED. Note that no external resistors are needed with this LED.
4.4.

SINGLE AV SWITCH WIRING

Spark 3™ can be controlled with a single switch. When using one switch some find an AV switch to be beneficial as
it incorporates an accent LED and switch into one hole.
The following diagram shows the same RGB wiring with the NECree RGrB LED, but using an AV switch instead of
two tactile switches. It is important to note that a single tactile works fine as well, but it does need to be a
momentary switch for the main button.
Also, when using this wiring configuration, ensure that the Button Layout dropdown is set to either "One Button"
or "One Button w/ Motion" in the NEC Editor.
Page | 12