Advertisement
CUTTING EDGE (Replacement)
Figure 5a
Figure 5b
Unscrew the bolt, B, located at the
-
bottom part of the shaft, at the A location
on the Live Edge cutting edge.
-
Take the bolt off the shaft inserted in the
spring, part C.
Disengage the spring, D, from the shaft
-
C.
-
The shaft, C, that was inserted in the
spring, can now be disengaged by a 45°
rotation.
-
Replace the Live Edge cutting edge and
reassemble in reverse order of dis-
assembly.
WEAR SHOES
Every Pro-Tech Sno Pusher® is equipped with
two hardened, abrasion resistant, bolt-on wear
shoes that are replaceable to provide seasons of
use by offering superior protection against wear
and tear. When replacement is required, follow
these guidelines:
WARNING:
Wear shoes are extremely heavy, please use
caution during the removal and installation
process.
STORAGE
Store the pusher in a location out of direct
sunlight and exposure to the weather to prevent
premature degradation of the cutting edge.
Properly clean the unit before storage and
remove dirt, debris, salt, etc. to extend paint life.
Pro‐Tech Manufacturing and Distribution, Inc.
711 West Ave ▪ Rochester, New York 14611
888‐787‐4766
www.snopusher.com
1. Lift Sno Pusher slightly off ground (2"-3")
and secure before attempting any
modifications.
2. Remove existing wear shoes by
removing the shoe retaining bolts, lock
nuts and collars. Then pull the wear shoe
off the mounting pins.
3. Lubricate all sliding surfaces of the wear
shoes, mounting pins, and retaining
collars with grease or never-seize.
4. Re-install wear shoes by sliding them
over the mounting pins and securing with
the shoe retaining bolts, lock nuts and
collars.
Advertisement
