Advertisement
ASSEMBLY
Before use, the sideplate assemblies (right and
left) need to be fastened to the chassis. First,
make sure that the chassis is lifted off the ground
and secured. Next, secure each sideplate
assembly to the chassis with (8) bolts on the
sideplate, (2) bolts on the rear support strut, and
(2) bolts thru the moldboard.
Note:
The compact wheel loader models (M)
have (7) bolts to fasten the sideplate.
Figure 1a
Figure 1b
ATTACHING THE UNIT: LEL and LEM
models equipped with post
configuration design
Attaching the Sno Pusher to your machine is
made easy with Pro-Tech's Quick Change™
Design.
Pro‐Tech Manufacturing and Distribution, Inc.
711 West Ave ▪ Rochester, New York 14611
888‐787‐4766
www.snopusher.com
1. Drive the cutting edge of machine's
bucket into the post receptacle on the
back of the Sno Pusher. (Figure 2a and
2b)
Figure 2a
Figure 2b
The bucket will come to rest against the
steel bucket stops. The upper posts will
fit inside the bucket and should be
centered. The lower posts will be
positioned under the bucket.
Advertisement
