Advertisement
2. Attach the chains and binders to secure
the Sno Pusher to your machine.
INSTALLING THE BINDER KIT
1. Grab hooks are to be welded to the side
or back corners of your machine's
bucket.
The location you choose MUST allow
chains to be positioned parallel to the
ground when attached. This will ensure
level operation of the Sno Pusher to your
machine.
2. Attach one section of transport chain to
the right side of the Sno Pusher using a
3/8" clevis. (Figure 3)
Drop opposite end of this chain into grab
hook on the right side of the bucket. Leave
enough slack (approx. 3"-4") in the chain to
allow vertical centering of the unit and
coupler.
3. Repeat step (2) to attach transport chain
to the left side of the Sno Pusher
Figure 3
Pro‐Tech Manufacturing and Distribution, Inc.
711 West Ave ▪ Rochester, New York 14611
www.snopusher.com
4. Now that both chains are in place, you
need to ensure full range of motion of the
floating coupler while maintaining contact
between your bucket and the inside of
the post receptacles.
NOTE:
If the pusher is slipping, then the chain is
too loose. Never try to "catch" the pusher
by "curling" the bucket. This could cause
damage to the Quick Change™ posts.
CAUTION:
Do not use the lift hooks located at the
top and rear of the Sno Pusher for chain
attachment. These hooks are designed
for lifting the unit only and not for
plowing.
For LEL, Chain Kit Includes:
2 – 10' sections of 3/8" P-43 Transport Chain
2 – 5/16" Grab Hooks
2 – 3/8" Shackles
For LEM, Chain Kit Includes:
2 – 5' sections of 3/8" P-43 Transport Chain
2 – 5/16" Grab Hooks
2 – 3/8" Shackles
888‐787‐4766
Advertisement
