Advertisement
ATTACHING THE UNIT: LEL models
equipped with a direct coupling
system
Your Pro-Tech Sno Pusher® Loader Model (LEL)
is equipped with the manufacturer's OEM Quick
Coupler. (Reference dimensions at end of
Owner's Guide)
1. Remove the bucket from your loader.
2. Drive machine into the coupler located on
the back of the Sno Pusher®.
3. Engage the locking pins.
NOTE: The coupler assembly may need
to be re-positioned to remain centered
and aligned with prime mover.
ATTACHING THE UNIT: LEM model
Your Pro-Tech Sno Pusher® Compact Wheel
Loader Model (LEM) is equipped with the
manufacturer's OEM Quick Coupler
1. Remove the bucket from your compact
wheel loader.
2. Drive machine into the adapter located
on the back of the Sno Pusher.
3. Engage the locking pins.
MAINTENANCE
Your Pro-Tech Sno Pusher® requires only
minimal service to remain in top condition. Follow
these simple guidelines to ensure proper plowing
and long life:
LIVE EDGE (Height Adjustment)
The height of Live Edge Cutting Edge™ can be
adjusted without any tools.
Note: Once the pusher is assembled, it will be
necessary to properly adjust the shoes to the
optimum cutting edge position. The shoes will
need to be adjusted so that only 1" to 1-1/4"
of cutting edge is below the bottom surface of
the shoe. Failure to set the height properly
can damage the plowing surface, the pusher,
or both.
Raise unit off the ground to access the rear of the
wear shoe. From the inside of the side plate
locate and remove the lynch pin. (Figure 4a)
Slightly raise the shoe upward to remove bearing
weight on the shoe pin. Remove shoe pin and
select desired adjustment position. Replace shoe
pin and lynch pin. Repeat on opposite side
maintaining the same hole height locations for
each.
Pro‐Tech Manufacturing and Distribution, Inc.
711 West Ave ▪ Rochester, New York 14611
888‐787‐4766
www.snopusher.com
Figure 4a
Figure 4b
Advertisement
