Table of Contents
Advertisement
SAFETY INSTRUCTIONS
2.9.2 Height indicator
The lifting beam is equipped with a sensor which controls the angle of the beam and indicates if
the maximum height is passed, in this case the red signal light turns on at the driver's post. The
signal light must be taken into account if the crane is positioned at the rear of the truck on top of
the load during transportation.
2.9.3 Adjusting the sensor
The crane is lifted to the rear of the truck so that its highest point is at the maximum height of the
vehicle (Figure 2.1).
After this the sensor is turned into its position (indicated by an arrow in figure 2.2), this turn on the
signal light. After this the sensor is tightened so that it cannot move.
Figure 2.1
Figure 2.2
24
Advertisement
Table of Contents
