Table of Contents
Advertisement
1.4
Quick Install
Installing the WhisperPower wpXXarm Touch Display involves the following steps. Please refer
to the individual sections for additional details.
1. Unpack the Box
3. Mount the Touch Panel
4. Connect the Touch panel
2.
Installation
2.2 Unpacking the Box
When unpacking the box containing the WhisperPower Touch Display,
you should find the following items:
-
1
The type of WhisperPower Touch Display you have ordered
-
1
A User's Manual
-
1
A RS232 Cable 1:1 connection to the WPC-RS232-I
-
1
RJ45 Converter cable/connector for generator cable
-
4
Screws with clip
If any of these items are missing or damaged, please contact WhisperPower.
2.3 Mounting the WhisperPower Touch Display
Install the Touch panel in vessel, vehicle or land based object. Take special care of the micro-
SD card on the side of the display. If the mounting hole is too narrow you could damage the
micro-SD card. Fix the panel with the 4 screws and clips.
2.4 Connecting the WhisperPower Touch Display
1. Remove the green 3 pole connector from rear side of the panel.
2. Connect the DC (plus and minus) and earth connection as shown on the rear side of the
panel.
3. Plug in again the 3 pole connector
4. Based on your situation connect the panel with the RS232 cable to the RS232-i
face and connect the RS232-i serial interface to the WPC and/or connect the panel with
the RS485 cable to the generator as per schematic below
WhisperPower Touch Display
WP 5.0, 7.0 and 10.0 inch
(Section 2.2)
(Section 2.3)
(Section 2.5)
5
serial
inter-
Advertisement
Table of Contents
