Advertisement
WARNING: Electrostatic Sensitive Device (ESD)
Static electricity can easily damage your motherboard and will void your motherboard warranty. Keep
the motherboard and other system components in their anti-static packaging until you are ready to
install them. Touch a grounded surface before you remove any system component from its protective
anti-static packaging. Unpacking and installation should be done on a grounded, anti-static mat. The
operator should be wearing an anti-static wristband, grounded at the same points as the anti-static mat.
During configuration and installation touch a grounded surface frequently to discharge any static
electrical charge that may have built up in your body. Avoid touching the components when handling
the motherboard or a peripheral card. Handle the motherboard and peripheral cards either by the
edges or by the peripheral card case-mounting bracket.
WARNING: Misplaced Jumper Damage
Incorrect setting jumpers and connectors may lead to damage to your motherboard and will void your
motherboard warranty. Please pay special attention not to connect these headers in wrong directions.
DO NOT change ANY jumprs while the motherboard has the power!
Application Notes:
Please read the following application notes before proceed with the system setup and/or OS installation:
1. Windows 10 Drivers Installation
It is recommended to load the ECM-3455J drivers with following
1. Install "Intel INF Driver".
2. Install "Intel Video Driver".
3. Install "Realtek LAN Driver".
4. Install "Realtek Audio Driver".
5. Install "Intel TXE Driver".
6. Install "Intel Serial IO Driver".
7. Make sure there is no exclamation mark shown for any device under Windows "Device Manager".
NOTE:
1. If any of the driver listed above can't be installed, you may update Win10 to the latest version through
Windows Update by connecting ethernet cable to one of two ECM-3455J onboard LANs.
2. If the Intel video driver is installed, and the video installer shows again after the system reboot, just close
it.
3. Win10 user may download "Intel Graphics Command Center" app from MS Store in order to access the
Intel video settings directly.
2. Boot Mode
The default boot mode is set as "UEFI". If you want to switch the boot mode to "Legacy", it can be
changed through BIOS option "Boot"->"Boot Mode Select". Then save and exit BIOS once in order
for the new boot mode to take effect.
3. Video Support
1. Under UEFI boot mode: The HDMI and LVDS will provide video signal simultaneously.
2. Under Legacy boot mode: Only
either
attached, please disconnect the HDMI monitor connection to ECM-3455J board in order for the video
signal to be switched to the LVDS panel).
4. Dual Role (OTG) Support
The "Port 0" of "F_USB2" header (the USB port pin 2, 4, 6, 8, 10, right next to the SATA header) can
support Dual Role when:
1. Set the BIOS option "Advanced"->"XDCI Support" to "Device Mode", then save and exit BIOS.
NOTE:
1. Dual Role is recommended to be used under Android or Linux OS with its own Dual Role driver
support.
2. Win10 doesn't provide Dual Role driver support.
sequence:
HDMI (default) or LVDS provides video signal. (if LVDS panel is
Advertisement
