Advertisement
11. Install the remaining doors.
11.1 Align the pins with the holes in the bulkhead
connection panel and install the rear door
(GM87237 or GM88932) on the alternator end of
the unit. See Figure 17 (item 1).
11.2 Align the pins with the holes in the base and install
the LH alternator panel (GM87236 or GM88931)
on the nonservice, alternator side of the unit. See
Figure 17 (item 2).
11.3 Align the pins with the holes in the base and install
the exhaust panel (GM87227 or GM88924) on the
nonservice side of the unit See Figure 17 (item 3).
Attach the top of the exhaust panel to the
mounting brackets in the top rail and secure using
two wing nuts (X-276-9). See Figure 14 for more
detail.
11.4 Align the pins with the holes in the base and install
the LH panel (GM87226 or GM88923) on the
nonservice side, engine end of the unit. See
Figure 17 (item 4).
11.5 Align the pins with the holes in the base and install
the front panel (GM87225 or GM88922) on the
engine end of the unit. See Figure 17 (item 5).
10
11.6 Align the pins with the holes in the base and install
the RH panel (GM87224 or GM88921) to the
service side, engine end of the unit.
Figure 17 (item 6).
11.7 Align the pins with the holes in the base and install
the RH alternator panel (GM87230 or GM88927)
to the service side, alternator end of the unit. Place
decal (GM93648) on RH alternator panel. See
Figure 17 (item 7).
11.8 Position the controller panel (GM87232) as
shown in Figure 17 and attach to the mounting
brackets in the top rail and secure using two wing
nuts (X-276-9). See Figure 14 for more detail.
12. Restore the generator set to service.
12.1 Reconnect the leads that were disconnected in
step 1.6. Position the controller into the controller
panel and secure using the existing hardware and
gasket (removed in step 1.7).
12.2 Check that the generator set master switch is in
the OFF position.
12.3 Reconnect the generator set engine starting
battery, the negative (--) lead last.
See
TT-1604 5/16
Advertisement
