New Holland 5500 Service Manual page 30

Big end bore diameter
Maximum connecting rod axis misalignment at
125.000 mm (4.921 in)
Maximum connecting rod weight difference over a
complete set from the same engine
NOTE: 6500 Big end bearing is without hole
Pistons
Piston diameter (Measured at 12.000 mm (0.472 in)
from base of skirt and right angles to pin)
Piston clearance in liner
• Maximum wear clearance
Piston oversize range
Piston stand-out with respect to head at TDC
Piston pin diameter
Piston pin seat bore in piston
Piston pin clearance in piston
Piston pin clearance in small end bushing
• Maximum wear clearance
Maximum weight difference between pistons on same
engine
Piston ring clearance in groove
• Top
• 2nd
• 3rd
Maximum wear clearance
• Top
• 2nd and 3rd
Piston ring gap
• Top
• 2nd
• 3rd
Maximum wear gap
Engine - Engine and crankcase
47899740 24/06/2015
10.1 [10.001] / 7
67.407 - 67.422 mm (2.654 - 2.654 in)
± 0.0700 mm (0.0028 in)
25.00 g (0.88 oz)
103.852 - 103.870 mm (4.089 - 4.089 in)
0.130 - 0.172 mm (0.005 - 0.007 in)
0.300 mm (0.012 in)
0.600 mm (0.024 in)
0.430 - 0.840 mm (0.017 - 0.033 in)
37.983 - 37.990 mm (1.495 - 1.496 in)
38.000 - 38.006 mm (1.496 - 1.496 in)
0.0100 - 0.0230 mm (0.0004 - 0.0009 in)
0.0140 - 0.0310 mm (0.0006 - 0.0012 in)
0.060 mm (0.002 in)
20.00 g (0.71 oz)
0.0900 - 0.1220 mm (0.0035 - 0.0048 in)
0.0600 - 0.0850 mm (0.0024 - 0.0033 in)
0.0400 - 0.0750 mm (0.0016 - 0.0030 in)
0.50 mm (0.02 in)
0.20 mm (0.01 in)
0.250 - 0.400 mm (0.010 - 0.016 in)
0.600 - 0.850 mm (0.024 - 0.033 in)
0.300 - 0.550 mm (0.012 - 0.022 in)
1.20 mm (0.05 in)