New Holland TI4.70 RS Service Manual page 14

1.2.1.1.6 Electricity
- Do not make makeshift connections. In particular, never make a connection by inserting the bare ends
of wires into socket holes;
- always disconnect a plug from the socket by gripping the outer casing of the plug itself, never pull the
cord;
- avoid twisted wires;
- take care not to damage the insulating sheath of wires and the insulated housings of electrical equipment,
and check frequently that they are undamaged;
- report any damage to electrical devices and, in particular, to earth conductors;
- never open electrical cabinets or the casings of electrical equipment and do not attempt to perform
maintenance on electrical cabinets and electrical equipment unless trained and authorised to do so;
- take all precautions to avoid contact with overhead power lines when manoeuvring or working in the
vicinity.
1.2.1.1.7 Fire
In areas and in operations subject to the risk of fire due to the proximity or use of flammable substances:
- do not smoke;
- do not use equipment involving naked flames and do not handle incandescent materials;
- keep flammable materials away from sources of heat;
- do not place materials in front of extinguishers and fire hydrants.
1.2.1.1.8 Dangerous substances and products
When using dangerous chemical products (fire hazard, explosion hazard, irritant, caustic burn hazard, burn
hazard or poisoning hazard), always observe the following precautions:
- keep recipients containing dangerous products open only for the time strictly necessary to use them;
- do not use or transfer dangerous products into containers not intended for use with them or without
the necessary labelling indicating the contents and safety markings;
- when using chemical products, follow the instructions given on the respective labels.
1.2.1.1.9 Protection against exposure to harmful gas, fumes and dust:
- check that any fume extraction systems in place are working correctly;
- use personal protective devices;
- place mobile extractor ducts as close as possible to the source of emissions;
- avoid closing using doors which will obstruct the air flow carrying emissions generated by the extractor
system.
INTRODUCTION
1-11