Canon BESTEM-D01R Manual page 6

Preface
Warning ! Before Using the System
■Caution when using the System
■Emergency Stop Button
● When any danger is upcoming, immediately press the emergency stop button, which is
installed at the front side of the system.
● Release the emergency stop button only after the cause of the trouble has been removed.
If you release the emergency stop button without checking, unexpected serious accidents
might occur. Further, never press the emergency stop button for a temporary halt (status) of
the system.
● There are 2 types of emergency stop buttons; one for shutting off all the machine drive
power supplies and the other for partly shutting off the machine drive power supplies. For
the details, see the paragraph of emergency stop in the text.
● Confirm the emergency stop button position for each machine.
● Recovery after Emergency Stop
Remove the cause of the emergency stop.
・ Pull back and release the emergency stop button.
・ After turning off the power, wait for about 10 seconds before turning on the power again.
・ Start-up the system following the procedures for the normal system start-up.
Caution Items during Operation
Please follow the caution items below
strictly due to safety and security
reasons when using our system.
●During the operation of this system,
never put parts of your body such as
hands or fingers in the action range of
driving parts or near to the high-voltage
area of the system for this may cause
serious injuries.
●The equipment should be operated by
one person.
●Caution when turning on a start-up
switch.
Regardless of manual or automatic
operation, execute the operation only
after confirmation that there is no
person or any tools etc.
ｉ
ｉ
2