3.
Roll the auger belt off the engine pulley. See Figure 23.
4.
Carefully pivot the snow thrower up and forward so that it rests on
the auger housing.
5.
Remove the frame cover from the underside of the snow thrower
by removing four self-tapping screws which secure it. See Figure
24.
6.
Remove the belt as follows. Refer to Figure 25.
a.
Loosen and remove the shoulder screw which acts as a belt
keeper.
b.
Unhook the support bracket spring from the frame.
SERVICE AND MAINTENANCE
A
20
Figure 23
Figure 24
B
Figure 25