Table of Contents
Advertisement
Symptom
No spray output.
Excessive over-
spray.
Unable to control
spray fan.
Runs and sags.
Material leaks from
cup.
Material leaks from
gun.
Thick, dimpled fin-
ish: orange peel
appearance.
Dry spray.
Contaminated
paint: fish eye
appearance.
Review the troubleshooting and procedures in this section if a problem develops with your tool.
If you need replacement parts or additional help with a procedure, call our Technical Support.
Model T23092 (Mfd. Since 04/11)
Possible Cause
1. No pressure at gun.
2. Fluid passages dirty.
3. Fluid control closed.
4. Out of paint.
5. Material too thick.
1. Fluid pressure too high.
2. Gun is too far from surface.
3. Spraying too fast.
1. Pattern adjustment screw is not
seating properly.
2. Atomizing cap is loose.
1. Damaged seal.
2. Too much fluid output.
3. Keeping gun in one place too
long.
1. Cap not secure.
2. Cup not tight on gun body.
3. Leaking from cap vent hole.
1. Fluid tip loose.
2. Dry or damaged seals.
3. Excessive pressure.
1. Holding gun too close to
surface.
2. Inlet air pressure too low.
3. Material not properly mixed.
4. Surface is dirty or oily.
1. Inlet air pressure too high.
2. Gun too far from surface.
3. Gun stroke too fast.
1. Water or oil in the air line.
Solution
1. Check air supply.
2. Clean gun, remove any
obstructions.
3. Open.
4. Refill.
5. Thin
to
manufacturer's
recommendations.
1. Reduce fluid pressure.
2. Keep gun at recommended
distance.
3. Slow down and maintain
consistent, even, parallel
stroke.
1. Clean or replace.
2. Tighten atomizing cap.
1. Replace damaged seal(s).
2. Use fluid control to reduce
flow.
3. Keep gun moving at a
steady pace.
1. Tighten.
2. Tighten.
3. Hold gun upright; do not tilt.
1. Tighten.
2. Replace seals.
3. Reduce pressure.
1. Spray
at
recommended
distance.
2. Check inlet air pressure.
3. Follow
manufacturer's
instructions.
4. More
surface
required.
1. Lower inlet air pressure.
2. Keep gun at recommended
distance.
3. Slow down and maintain
even, parallel stroke.
1. Install an in-line air filter;
replace air line.
prep
is
-15
-
Advertisement
Table of Contents
