Installation - Linea 2000 DOMO DO91606W Manual

PARTS
1. Control panel
2. Large wooden racks
3. Small wooden rack
4. Ventilation openings
5. Door
6. Handle
7. Levelling feet

INSTALLATION

· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth. Dry the appliance off well.
· Use two or more people to move and install the appliance. Failure to do so can result in back or other
injury.
· Make sure that the air can circulate around the appliance. Therefore, leave a free space of at least 5 cm
between the appliance and any other object.
· Make sure there is sufficient space to open the door.
· To ensure proper ventilation for your appliance, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 16°C (60°F) and below 32°C
(90°F). This unit must be installed in an area protected from the elements, such as wind, rain, water
spray or drips.
· This cooling appliance is designed to be for free-standing or built-in installation.
· Place the appliance on a firm, steady surface, that is strong enough to carry a filled wine cooler.
· Do not place the appliance directly into sunlight or near heat sources. Direct sunlight could affect
the coating of the appliance and the proximity of heat sources may cause an increase of the energy
consumption. Extreme temperatures may also cause malfunctioning of the appliance.
· Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the
evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
· The cord should not be exposed or left hanging loose to prevent possible accidents.
· After installation, leave the refrigerator for 24 hours before turning it on. This way the refrigerant can
settle.
· Before connecting the appliance to the power net, leave it standing upright for about 2 hours. This
reduces the risk of any malfunctioning of the cooling system due to transportation.
· Allow the appliance to run empty for 8 hours so the compartment can cool to the appropriate
temperature.
· One can level the appliance using adjustable legs. The adjustable legs can be adjusted by screwing
them in or out of the appliance.
www.domo-elektro.be DO91606W-DO91608W
33