Table of Contents
Advertisement
Operating
1
2
1
2
3
2
Clamp bar cover:
To prevent clamp bar pressure marks on
sensitive materials, a clamp bar cover
provided (tool panel).
Dismantling:
• Remove clamp bar cover
hand or gently press into the recess using
the provided spanner ( in the tool kit).
The narrow cut is 15 mm.
Assembly:
• Clip the clamp bar cover
the clamp bar
(for status indicator see Page 15)
The narrow cut is 60 mm.
Cutting activation / Clamping
Caution!
Never reach into the cutting area when the blade
is in motion.
Only when the specified dimension is moved to
can a cut be activated.
• Release the light beam curtain protective area
• Simultaneously press both operating buttons
of the two-hand activation system and keep
2
pressed until end of the cut.
• Clamping is done automatically by actuating
the operating buttons
paper can also be pre-pressed beforehand
with the foot pedal
• Move back gauge forwards before turning the
stack of paper.
• Blade must always be at the top and covered
by the clamp, do not touch the blade (see Page 26).
Injury risk.
Termination of cutting
Release both operating buttons
two-hand activation system.
12
downwards by
1
1
upwards into
.
2
before cutting. The
2
.
3
of the
2
is
1
.
1
Advertisement
Table of Contents
