Related Manuals for LaserLiner X2-Laser
Summary of Contents for LaserLiner X2-Laser
- Page 1 X2-Laser Laser 1H360° 2V 1P 515 nm...
-
Page 2: Function / Application
X2-Laser Completely read through the operating instructions, the „Warranty and Additional Information“ booklet as well as the latest information under the internet link at the end of these instructions. Follow the instructions they contain. This document must be kept in a safe place and if the laser device is passed on, this document must be passed on with it. -
Page 3: Special Product Features
– Attention: Do not look into the direct or reflected beam. – Do not point the laser beam towards persons. – If a person‘s eyes are exposed to class 2 laser radiation, they should shut their eyes and immediately move away from the beam. –... - Page 4 X2-Laser Green laser technology Devices with PowerGreen++ technology have extremely bright green laser diodes of the highest performance class that allow very good visibility of laser lines at great distances, on dark surfaces and in bright ambient lighting conditions. Approx. 6 times brighter than a typical red laser with 630 - 660 nm...
- Page 5 Use of lithium-ion rechargeable battery – The power supply unit is to be used in enclosed spaces only; do not expose to moisture or rain as this may result in the risk of electric shock. – Charge the device‘s battery completely prior to use.
- Page 6 X2-Laser Horizontal and vertical levelling Release the transport restraint, push the slide switch (2) to the left. The horizontal laser line appears. The laser lines can be switched individually with the selection button. LASER LASER LASER LASER The transport restraint must be released for horizontal and vertical levelling.
- Page 7 Hand receiver mode Optional: Working with the laser receiver GRX Use an GRX laser receiver (optional) to carry out levelling at great distances or when the laser lines are no longer visible. To work with a laser receiver, switch the line laser to hand-held receiver mode by keeping button 6 (hand-held receiver mode on / off) pressed.
- Page 8 4. Turn the device through 180° and mark point A3. The difference between points A2 and A3 is the tolerance. When A2 and A3 are more than 0.2 mm / m apart, an adjustment is necessary. Contact your authorised dealer or else the UMAREX-LASERLINER Service Department.
- Page 9 Checking the vertical line Position the device about 5 m from a wall. Fix a plumb bob with a line of 2.5 m length on the wall, making sure that the bob can swing freely. Switch on the device and align the vertical laser to the plumb line. The precision is within the specified tolerance if the deviation between the laser line and the plumb line is not greater than ±...
- Page 10 X2-Laser Technical data (Subject to technical changes without notice. 20W41) Self-levelling range ± 3° Accuracy ± 0.2 mm / m Levelling auto Visibility (typical)* 60 m Working range with hand receiver (depends on how the technology 60 m affects the difference in brightness)
-
Page 11: Algemene Veiligheidsaanwijzingen
Lees de handleiding, de bijgevoegde brochure ‘Garantie- en aanvullende aanwijzingen’ evenals de actuele informatie en aanwijzingen in de internet-link aan het einde van deze handleiding volledig door. Volg de daarin beschreven aanwijzingen op. Bewaar deze documentatie en geef ze door als u de laserinrichting doorgeeft. Functie / Toepassing Groene kruislijnlaser met horizontale lasercirkel en twee verticale lijnen –...