Table of Contents
Advertisement
To Set Up
continued
Step 4
■ Place a 20 lb.
propane cylinder
in the right tank
mount and secure
as shown.
(Fig. 23 & 24)
NOTE: Point
cylinder valves
toward front of
grill.
NOTE: Each
cylinder provides
fuel to only one
side of the grill.
Step 5
NOTE: Storage position for the regulator is above the grease pan.
■ Unlock the grease pan (located on the back side of the grill). (Fig. 25)
■ Slide the grease pan half way out. (Fig. 26)
Fig. 25
■ The storage position for the regulator is above the grease pan. (Fig. 27)
■ Remove the regulator from the clip attached to the bottom of grill. (Fig. 28)
Fig. 27
■ Attach the regulator to the
propane cylinder connection
and hand-tighten. (Fig. 29)
■ Repeat Step 4 and Step 5 to
attach the second cylinder on
the left side.
8
Fig. 23
Fig. 24
Fig. 26
Clip
Fig. 28
Fig. 29
Step 6
LEFT LID (SHELF)
CENTER LID
■ Unlock Right Lid.
NOTE: Undo latches on
front and back of lid.
(Fig. 30)
■ Release lid flaps to
form Right Shelf. (Fig. 31)
IMPORTANT: Always remove Lids in this order:
•
Right Lid first.
•
Left Lid second.
•
Center Lid last.
■ Carefully insert Shelf Lip
on Right Side Shelf into Top
Channel, while at the same time
making sure the Notches on the
side Flaps fit into the Flanges
on the grill body. (Fig. 32 & 33)
■ Repeat the same order for attaching the Left Side Shelf as you did
on the Right Side Shelf.
■ Remove Center Lid and set aside until ready for storage of the grill.
RIGHT LID (SHELF)
LID FLAPS
SHELF LIP
TOP CHANNEL
NOTCH
FLANGE
Fig. 30
Fig. 31
Fig. 32
Fig. 33
Advertisement
Table of Contents
