Dual Arm Tool Changer - FADAL VMC 3020 Operator's Manual

Fadal

Dual Arm Tool Changer

62
Note: Machine must be in JOG mode. Multiple key combinations are
required to move the dual tool arm changer.
Bucket Up-Bucket Down
The bucket will motion either up or down
depending on its previous position.
Press and hold the SPINDLE STOP (d),
FEED STOP (e), and CYCLE STOP (g) red
hard keys and the blank key (a)--located
between the MPG and the TOOL IN/OUT
hard keys.
Move Arm Forward
The arm will motion forward--depending
on its previous position.
Press and hold the SPINDLE STOP (d),
FEED STOP (e), and CYCLE STOP (g) red
hard keys and the blank key (b)--located to
the left of the TURRET CW hard key.
Move Arm Backwards
The arm will
depending on its previous position.
Press and hold the SPINDLE STOP (d),
FEED STOP (e), and CYCLE STOP (g) red
hard keys and the blank key (c)--located to
the left of the red SPINDLE STOP hard key.
Fadal/Sinumerik 810D CNC: Bucket Up-Bucket Down
motion backwards--
SIEMENS CONTROL
Operator Manual
a
b
c d
e
g
f
a. Blank key
b. Blank key
c. Blank key
d. Spindle Stop
e. Feed Stop
f. Reset
g. Cycle Stop
October 2000