FADAL VMC 3020 Operator's Manual page 35

Fadal
October 2000
7) Toggle to the MCS display. The WCS base position for the machine will
be displayed. In the example below the X-Axis was jogged to +1.00". The
MCS display for the X-Axis now shows the Machine Zero (Cold Start)
position is -1.00 inches away from the base position set for the X-Axis in
the WCS.
8) To set the Y and Z axes base position, perform steps 1-6 for each axis.
Use the cursor key pad arrows to highlight the appropriate axis.
Fadal/Sinumerik 810D CNC: Definition of Offsets
SIEMENS CONTROL
Operator Manual
35