Tool Wear Table - FADAL VMC 3020 Operator's Manual

Fadal
Note:
October 2000

Tool Wear Table

The operator has the option to adjust the tool length or the tool diameter
by an incremental value.
1) Press the OFFSET hard key.
2) Press the Tool Wear soft key.
3) Use the cursor keypad arrows, cursor down and over to
highlight tool length or diameter.
4) Type in incremental amount then press the INPUT hard key.
When tool length offset is reset by choosing SET LENGTH from the OFFSET
page, wear offsets will be zeroed.
Fadal/Sinumerik 810D CNC: Definition of Offsets
Length Diameter
SIEMENS CONTROL
Operator Manual
51