Makita HM001G Instruction Manual page 11

Dust extractor attachment
Optional accessory
1. Install the hose holder (A/B).
When the side handle is installed to tool, loosen the
clamp nut, and then remove the hex bolt. Install the
hose holder (A) between the hex bolt and the clamp nut
by tightening the clamp nut firmly.
3
► 1 . Hex bolt 2. Hose holder (A) 3. Clamp nut
When the side grip is installed to the tool, loosen the
side grip, mount the hose holder (B) to the shaft, and
then tighten the side grip firmly.
1
2
► 1 . Hose holder (B) 2. Shaft 3. Side grip
1
2
3
2. Attach the holder joint to the tool, and then attach
the hose holder (C) to the holder joint.
► 1 . Holder joint 2. Hose holder (C)
NOTE: The hose joint can be attached to either side
of the tool.
WARNING:
only for attaching the holder joint.
Using the mounting part for any other purpose may
cause an unexpected accident.
3. Attach the dust cover and the hose to the tool, and
then fix the hose to the hose holders.
1
► 1 . Dust cover 2. Hose 3. Hose holder (A/B) 4. Hose
holder (C)
11 ENGLISH
Use the mounting part of the tool
2 3
1
2
4