Makita HM001G Instruction Manual page 10

Side grip (auxiliary handle)
The side grip can be swung, allowing easy handling of the tool in any
position. Loosen the side grip by turning it counterclockwise, swing it
to the desired position and then tighten it by turning clockwise.
1
► 1 . Side grip
Installing or removing bit
Grease
Clean the shank end of the bit and apply grease before
installing the bit.
Coat the shank end of the bit beforehand with a small
amount of grease (about 0.5 - 1 g). This chuck lubrica-
tion assures smooth action and longer service life.
1
► 1 . Shank end 2. Grease
Insert the bit into the tool. Turn the bit and push it in until
it engages. After installing the bit, always make sure that
the bit is securely held in place by trying to pull it out.
► 1 . Bit
2
1
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
2
► 1 . Bit 2. Chuck cover
Bit angle
The bit can be secured at 12 different angles. To
change the bit angle, slide the change ring forward,
then turn the change ring to change the bit angle. At the
desired angle, slide the change ring back to the original
position. The bit will be secured in place.
After changing the bit angle, make sure the angle is
fixed by trying to rotate the bit.
► 1 . Change ring
10 ENGLISH
1