Advertisement
Remove the protective cover on the left side of the printer.
Hold the protective cover by both sides, and while pushing
the left side of the cover ( ), open it in the direction of
the arrow ( ), and then remove ( ).
ZDJP041J
Note
You cannot use the removed protective cover.
Attach the paper guide to the stand. Hold it so that the
right side bends down as shown, and then while gripping
lightly ( ), insert it into the holes of the stand ( ).
ZDJP042J
Insert the claws of the stand into the holes on the left side
of the printer ( ), and then push down ( ).
ZDJP043J
Slowly open the front cover by pulling on the two areas on
the left and right.
ZDJH007J
All manuals and user guides at all-guides.com
Remove the green screwdriver, and then close the front
cover.
Use this screwdriver for all attachment and detachment of screws.
ZHXH171J
Note
After using the screwdriver, return it to its original position on
the inside of the front cover.
Tighten the four long screws fastening the duplex reversal
unit stand, using provided screwdriver. Fasten in the
c
c c , as shown.
order of
ZDJP044J
This completes the installation of the stand. Next, install the duplex reversal unit.
Installing the Duplex Reversal Unit
With both hands, hold the duplex reversal unit level, and
then insert the hooks into the groove of the stand. Adjust
the tip of the hooks to the line on the stand, as shown,
and then insert slowly. Do not let go of the duplex reversal
unit even after insertion.
ZHXH250J
The hooks of the duplex reversal unit clip around the bar inside the groove of the
stand.
Advertisement
