Yamaha WOLVERINE X2 Owner's Manual page 153

1
1. Tailpipe bolt
2. Remove the tailpipe by pulling it out of
the muffler, and then remove the gasket.
3. Tap the tailpipe lightly, and then use a
wire brush to remove any carbon depos-
its from the spark arrester portion of the
tailpipe and inside of the tailpipe housing.
1
1
1. Tailpipe
2. Spark arrester
3. Gasket
4. Install the gasket, and then insert the tail-
pipe into the muffler and align the bolt
holes.
TIP
Make sure that the tailpipe is positioned at a
45° angle as shown.
9-37
2
3
9