Operations; Basic Operations; Switching The Display; Selecting A Mode - Clarion ADB340MP ADB340MP ADB340MP Owner's Manual

5. OPERATIONS

Basic Operations

CAUTION
Be sure to lower the volume before switch-
ing off the unit power or the ignition key. The
unit remembers its last volume setting. If you
switch the power off with the volume up, when
you switch the power back on, the sudden
loud volume may hurt your hearing and dam-
age the unit.
The clock is displayed when the ignition key
is turned to the ACC (accessory) or IGN (igni-
tion-on) position even when the unit power
is off. In some cars, the clock may momen-
tarily disappear when the ignition key is
turned to the START position. The clock will
reappear after the engine has started and the
ignition key is released to the IGN (ignition-
on) position.
Turning on/off the power
Notes:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car's bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.
1. Press the [FNC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [FNC] button for 1 second
or longer to turn off the power for the unit.

Selecting a mode

1. Press the [FNC] button to change the mode
of operation.
2. Each time you press the [FNC] button, the
mode of operation changes in the following
order:
Radio mode CD mode
AUX mode Radio mode...

Adjusting the volume

Turning the [VOLUME] knob clockwise to in-
crease the volume, or turning the [VOLUME]
knob counterclockwise to decrease the volume.
The volume level is from 0 (minimum) to 35 (maxi-
mum).
8
ADB340MP/ADB341MP
Note: Be sure to read this chapter referring to the front diagrams of
chapter "3. CONTROLS" on page 5 (unfold).
Mute
Turning the volume down quickly.
Press the [MUTE] button.
Each time the button is pressed the Mute turns
ON or OFF.
When it's ON, the "MUTE" indicator blinks.

Switching the display

Press the [DISP] button to select the desired dis-
play.
Each time you press the [DISP] button, the dis-
play switches in the following order:
Frequency
Clock
Playback direction & Current status
status
status...
Tape mode
In Tuner source
Clock Frequency...
In CD source
Track Number & Track Time
In Tape source
Clock Playback direction & Current
Once selected, the preferred display becomes
the display default. When a function adjustment
such as volume is made, the screen will mo-
mentarily switch to that function's display, then
revert back to the preferred display several
seconds after the adjustment.
When you have entered a title in a CD, it ap-
pears in the main display. If you have not en-
tered a title, "NO-TITL" appears in the title dis-
play instead. For information on how to enter a
title, refer to the subsection "Entering titles"in
the "Operations Common to Each Mode".
Clock...
Current