Adjusting Printer Settings
Many preset functions can be accessed easily using the 4 bit DIP switches on the
bottom of the printer.
Please use these switches to meet your desired purpose.
When the unit powers up it reads the DIP setting one time only, and carries out the print
operations following those instructions.
n
SW Assignments
The mode switch function is assigned to DIP switch SW1.
This switch functions to extend the possible settings to 6 as the remaining 3 Switches
operate under two modes, ON/OFF.
Each setting item is explained below.
SW1 : Extension Switch
SW2 : A4-->A6 Reduce print
SW3 : Manual Paper Feed
SW4 : Reverse Paper Feed Switch
SW1 : Extension Switch
SW2 : Not used
SW3 : HEX print mode
SW4 : VuePrint function set mode
★
Set to "OFF" at the Factory before delivery.
ON
1
2
3
4
[Mode 1 = OFF side]
[Enable/Disable = ON/OFF]
[Enable/Disable = ON/OFF]
[Enable/Disable = ON/OFF]
[Mode 2 = ON side]
[Enable/Disable = ON/OFF]
[Enable/Disable = ON/OFF]
[Enable/Disable = ON/OFF]
– 22 –