Notes On Settings; Notes On Handling - Fujitsu PG-HD9G1C User Manual

3 Notes on Settings

If the setting pins need to be changed, use caution to prevent damage to the PC board
●
beneath them.
Do not touch any other pins and/or switches other than the SCSI ID/Terminator setting
●
pin.

4 Notes on Handling

CAUTION
!
The hard disk is a precision device. Strictly observe the following when handling the prod-
uct; otherwise, the product and/or the data in the disk may be destroyed.
Do not touch the connector section and/or the component installation surface of the PC
●
board when handling the product.
Be sure not to drop or mishandle the product in any way until the bottom of the product
●
completely touches the desk surface when the product is to be placed on the desk.
Before carrying out the following operation, turn off the power and wait until the disk
●
completely stops rotating (about 30 seconds).
– Removing this product
– Changing the settings
Do not use or store the product in the following locations:
●
– Near a magnet or strong magnetic field
– Near a heater or anywhere the product would be exposed to direct sun light
– Any location subject to extreme temperature or humidity changes
– Any wet or dusty location
– Any location subject to vibration or shock
Use a soft dry cloth to wipe dust from the product. Do not use volatile agents such as
●
benzine or thinner.
Do not disassemble the product.
●
Do not touch pins other than the setting pins.
●
E
3