Maintenance; General; Replacing Display Light Bulbs - Hatco Ultra-Glo UGA Series Installation And Operating Manual

MAINTENANCE

General

Hatco Ultra-Glo Strip Heaters are designed for
®
maximum durability and performance with minimum
maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Unplug the power cord or turn the power OFF
at the fused disconnect switch/circuit
breaker and allow the unit to cool before
performing any maintenance or cleaning.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if unit
has been submerged or saturated with water.
This unit has no "user-serviceable" parts. If
service is required on this unit, contact an
Authorized Hatco Service Agent or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
NOTICE
Use non-abrasive cleaners only. Abrasive
cleaners could scratch the finish of the unit,
marring its appearance
susceptible to dirt accumulation.
Cleaning
To preserve the finish of the strip heater, it is
recommended that the surfaces be wiped daily with
a clean, soft, damp cloth. Stubborn stains may be
removed with a good stainless steel cleaner or a
non-abrasive cleaner. Hard to reach areas should
be cleaned with a small brush and mild soap.
All manuals and user guides at all-guides.com
and making it
18

Replacing Display Light Bulbs

WARNING
Use only light bulbs that meet or exceed
National Sanitation Foundation (NSF) standards
and are specifically designed for food holding
areas. Breakage of light bulbs not specially
coated could result in personal injury and/or
food contamination.
The display light is either an incandescent bulb or
halogen bulb that illuminates the warming area. This
bulb has a special coating to guard against injury and
food contamination in the event of breakage.
To replace a bulb, disconnect the power supply and
wait until the unit has cooled. Display lamps have a
threaded base. Unscrew the bulb from the unit and
replace it with a new specially coated incandescent
bulb. Hatco shatter-resistant bulbs meet NSF
standards for food holding and display areas.
NOTE: Hatco shatter-resistant light bulbs meet
NSF standards for food holding and display
areas. For 120, 120/208, and 120/240 volt
units use the following Hatco part numbers:
Incandescent Bulb = 02.30.043.00
Halogen Bulb = 02.30.081.00
For 240V export units use:
Incandescent Bulb = 02.30.058.00
WARNING
ELECTRIC SHOCK HAZARD: Use only Genuine
Hatco Replacement Parts when service is
required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and
may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco
Replacement Parts are specified to operate
safely in the environments in which they are
used. Some aftermarket or generic replacement
parts do not have the characteristics that will
allow them to operate safely in Hatco
equipment.
Form No. UGAM-0908