CONTROL Lock and Centralised Control Setting ............34 POWER On/off Setting ....................35 ANDROID Homepage ....................35 ANNOTATE .......................36 WHITEBOARD Software ...................36 DOCUMENTS Manager ....................37 FLOATING Toolbar and Quick Menu ................37 TECHNICAL Parameters ................38 TROUBLESHOOTING ..................39 JTouch-00-RS232-Commands ..............41 NETWORK Service ..................45 www.infocus.com...
Page 3
DISPOSING of your used product In the European Union .........51 RF INTERFERENCE (for USA only) ................51 MANUFACTURER, EU importer and EU Authorised Representative in accordance with EU DIRECTIVES ....................53 EU Declaration of Conformity ................. 54 UK Declaration of Conformity ................ 55 WARRANTY ....................56 www.infocus.com...
Failure to observe this information can result in injury or equipment damage. InFocus shall not be liable for any damages or problems arising from the use of any options or any consumable products other than those designated as original InFocus products or InFocus approved products by InFocus.
United States and other countries. • HDBaseT® is a trademark of HDBaseT® Alliance. • InFocus, InFocus LightCast, IN, LightPro are registered trademarks of InFocus Corporation. • Trademark PJLink® is a trademark applied for trademark rights in Japan, the United States of America and other countries and areas.
Page 6
3. Great care has been taken in the preparation of this guide; however, should you notice any questionable points, errors or omissions, please contact us. 4. Notwithstanding article (3), InFocus will not be responsible for any claims on loss of profit or other matters deemed to result from using the Interactive Touch Display.
Continuing to use under these conditions may result in fire or electric shock. Do not try to repair this Interactive Touch Display yourself. Refer all repairs to qualified service personnel. Place the Interactive Touch Display near an outlet where the plug can be easily unplugged. www.infocus.com...
Page 8
If installation work is not carried out correctly, the Interactive Touch Display could fall down. This may result in injury or accidents. Contact your InFocus authorized dealer to carry out the installation work. If you use a wall mount do not apply adhesives to the mount to prevent...
Page 9
• Keep the power cable away from hot electrical appliances. • Do not tie the power cable to other cables. Contact your InFocus authorized dealer if the cable becomes damaged. Cables should be wired so that they cannot trip people up and so on. This could cause people to fall and be injured.
Do not install the Interactive Touch Display in a location that is not strong enough to bear its weight, or on an unstable surface such as a table that shakes or is tilted. The Interactive Touch Display may fall down or tip over causing damage, deformation, or injury. www.infocus.com...
Page 11
The insulation may deteriorate, which may result in fire. Be sure to check that the power is turned off, the plug is disconnected from the outlet and all cables are disconnected before moving the Interactive Touch Display. Fire or electric shock may result. www.infocus.com...
Page 12
Do not allow a still picture or an active picture containing stationary text or icon to remain on the screen of the Interactive Touch Display for too long because this will leave a "ghost image" on the screen, and it will not disappear long after shutdown. www.infocus.com...
IEC 60417, Caution Hot Surface. To indicate that the marked item can be hot and should not be touched without taking care. IEC 60417 Symbol No. 6042 ISO 3864-B3.1, Caution Risk of Electric Shock. To identify equipment that has risk of electric shock. www.infocus.com...
Getting the latest version of documents You can get the latest version of this users guide as well as other product information and literature by visiting the InFocus website. Visit infocus.com and enter your Interactive Touch Display model number in the search box.
• This product is preinstalled with a professional writing software. It provides multiple types of pens, drawing tools and other functions, and you can write and move USB A-A HDMI the contents as you like. Cable x 1 Cable x 1 www.infocus.com...
The initial start-up screens with notes and details are as follows: 1. Welcome Screen 2. Network Selection Select the method to connect to your desired network www.infocus.com...
Page 17
Initial start-up If your desired network or network access point is password protected, you will be promoted to enter a password. Clicking in the password popup dialog box will bring up the onscreen keyboard. www.infocus.com...
Page 18
Initial start-up Once you have keyed in your password it will take a few moments for the device to connect to your selected network. 3. Select Your Language Press more to view available languages and to make your language selection. www.infocus.com...
Page 19
In this setting screen you have several options. You can toggle between a 24 hour or a 12 hours am/pm format. You can select the time to by synchronised automatically from your network or manually by inputting the time and the time zone. www.infocus.com...
Page 20
If you wish to make changes to the initial set up, you can go back a single or multiple steps in the process by selecting the back arrow button (bottom left of each screen). Change or confirm your settings and then selecting the forward arrow button (bottom right of screen) to continue. www.infocus.com...
Note The maximum resolution supported by HDMI port is 4K@60HZ, please see the section of technical parameters for the detailed signal formats. When 4K@60HZ signals are played, the EDID version in the OSO menu should be switched to EDID2.0. www.infocus.com...
Page 22
AV cable AV output device Note The type of AV-IN port is <l>3.5mm MINI port. For connecting signals, a MINI adapter cable or a MINI adapter and an AV cable are required and connected as indicated by the figure. www.infocus.com...
The HDMI-OUT port can output Audio & Video signals to the HDMI-IN port of the second product, the second product can replay the Audio & Video signals to the third product. The maximum relaying amount depends on quality and length of the HDMI cable. www.infocus.com...
Optical fiber cable SPDIF- IN port. Audio-Out port Note Audio-OUT port can be connected with a headset or an Earphone external speaker. Control ports RS232 port Note RS232-IN port is connected to the PC; the product is operated via the PC. www.infocus.com...
INSTRUCTION OF PANEL BUTTONS Instruction of Panel Buttons Indicator light, remote control receiver and light sensing receiver Power on/off Homepage Return and touch unlock Settings Vol- Vol+ Main power switch www.infocus.com...
Do not throw batteries into a fire or recharge or disassemble batteries. Do not recharge, short-circuit, disassemble/assemble, heat or burn any used batteries. Please dispose of waste batteries according to applicable environmental regulations. Do not expose batteries to any hot environment, like direct sunlight, over the fire. www.infocus.com...
Page 27
VOL - Decrease the volume. Note MUTE The picture is for reference only, subject to Enable/disable sound. the actual remote control. VOL + Functions of keys on the remote control Increase the volume. may vary, subject to actual functions. www.infocus.com...
1. Press the "Signal Source" key on the remote controller to call "Signal Source Menu 2. Press the cursor key on the remote control to select a signal source 3. Press the"OK" key, and then the product will switch to the input signal source that you selected. www.infocus.com...
Upon the signal source menu, select the right one and enter the signal source setting submenu, it can set the signal source auto-switching, signal source lock, power-on signal source and auto-power off without signal. All Source Source Setting Automatic Source Jump Source Priority Source Lock Boot Source No Signal Automatic Shutdown www.infocus.com...
4. Select "DHCP" in IP settings, and then the machine will automatically obtain an IP address and connect to network. 5. Select "Static" in IP settings, manually input IP address, gateway, network prefix length, DSN address, and then click "Finish" to connect to network. www.infocus.com...
Page 32
6. Click "OK" to save setting, and then this network can be found by other WIFI devices within the range when they search WIFI networks. Note Please set the network password using 8-12 characters that contain uppercase characters, lowercase characters, numbers and symbols. www.infocus.com...
Select sidebar menu, press setting icon and enter system setting page, it can set wallpaper, screen-lock background, no signal image, count-down, password alteration, start-up screen lock, factory data resetting, automatic checking for updates, manual checking for updates, Android application management , etc.., when move down to system setting and applications page. www.infocus.com...
LCD. Gesture on/off can set gesture to switch to sidebar menu( slide from the side of screen to the central), bottom-bar menu( slide upwards from bottom left of the screen), and floating ball menu( tune-out with three-finger touch). www.infocus.com...
LAN, timing switcher, startup time, shutdown time and so on when move down to power on/off setting. Android Homepage There are time, date, flash drive information, network information, hot spot information and shortcuts for whiteboard and file manager on the home page. Ali apps include system apps and third party apps. www.infocus.com...
Use the tools to mark up documents, save or share the pictures when finished. Whiteboard Software The electronic whiteboard writing software contains selection, background setting, brush setting, undo, restore, text, clear screen, save, import picture, spot light and split screen and other functions. www.infocus.com...
This contains the main screen applications and can be opened on any screen. Swipe up along the edge of the bottom left/right corner of the screen to open the bottom menu bar, this contains the Help, Volume and Floating toolbar shortcuts. www.infocus.com...
Too many programs are Clean up a program that uses doesn’t work running large memory or restart the product OPS can’t be turned The OPS has not been Reinstall the OPS computer on, no display, no connected correctly touch www.infocus.com...
Page 40
USB cable the touch USB cable 2. Use a shorter or better 2. The touch USB cable is too quality touch USB cable long or of low quality www.infocus.com...
JTouch-00-RS232-Commands JTouch-00-RS232-Commands InFocus JTouch 00 Series RS232/LAN Commands INF6500, INF7500, INF8600, INF9800 The JTouch 00 can be connected by RS232 or LAN port. Connection Details on the settings can be found below under each connection type. Baud Rate 38400bps Data bit...
Page 44
To wake the display from standby mode when using LAN connection is only possible by sending a MAC address command. Download tool Netwaker.exe from https://drive.conxme.com/s/iBLJG72QxyFWAf3 Enter the MAC address of the display and press button to the right side. This will send a signal to the display and wake from standby mode. www.infocus.com...
Third-party services may be subject to change, removal or discontinuation without prior notice. InFocus does not represent or warrant that some services or contents will remain accessible at any time.
The environment-friendly use period of this product is 10 years (see the pollution control symbol in the right figure). Such use period will be maintained under the normal working conditions specified in the User's Manual only. www.infocus.com...
The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries. www.infocus.com...
Getting help Contacting InFocus InFocus technical support can be contacted at the below phone numbers within the stated operating hours, by using the enquiry form links provided or by visiting infocus.com and clicking on the chat support icon found on every page.
Using the product continuously longer than the recommended time frame may result in image ghosting or screen image burn-in which is not covered under the limited warranty. www.infocus.com...
Product. Third-party services may be subject to change, removal or discontinuation without prior notice. InFocus does not represent or warrant that some services or contents will remain accessible at any time.
Warning The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by InFocus in this manual. Failure to comply with this government regulation could void your right to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 52
EEE Yonetmeligine Uygundur. This device is not intended for use in the direct field of view at visual display workplaces. To avoid incommoding reflections at visual display workplaces this device must not be placed in the direct field of view. www.infocus.com...
Russian Authorised Representative InFocus has appointed AUVIX LLC, 129085, c. Moscow, Zvezdny Boulevard, 21, bldg. 1. as the authorised representative in Russia and this product is compliant with TR TC 004/2011, TR TC 020/2011 and TR CU 020/2011 local conformity testing and approvals.
WARRANTY WARRANTY INFOCUS LIMITED WARRANTY For product purchases effective 1st January 2021 WARRANTY STATEMENT In Focus warrants its products to be free from defects in material and workmanship during the warranty period. If a product proves to be defective in material or workmanship during the warranty period, In Focus will, at its sole option, repair or replace the product with a similar product.
Page 57
OBTAINING WARRANTY SERVICE Submit your request to us on line: https://infocus.com/support/technical-support/or call your local In Focus support hotline which can be found at: https://infocus.com/ support/contact-us/ Be sure to read our RMA instruction closely to ensure a smooth and timely process of your report, these will be sent to you with the RMA confirmation.
Page 58
TO THE EXTENT ALLOWED BY LOCAL LAW, THIS PRODUCT IS PROVIDED TO YOU "AS IS" WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, WHETHER ORAL OR WRITTEN, EXPRESS OR IMPLIED. INFOCUS SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY, SATISFACTORY QUALITY, NON INFRINGEMENT AND FITNESS FOR A PARTICULAR PURPOSE.
Need help?
Do you have a question about the JTouch 00 Series and is the answer not in the manual?
Questions and answers