Maintenance - Makita HR2652 Instruction Manual

2. Open the cover of the dust case.
► 1 . Cover
3. Dispose of the dust, and then clean the filter.
NOTICE:
When cleaning the filter, do not touch
the filter with brush or similar, or blow com-
pressed air on the filter. It may damage the filter.
Blow-out bulb
Optional accessory
After drilling the hole, use the blow-out bulb to clean the
dust out of the hole.
Using dust cup set
Optional accessory
Fit the dust cup set against the ceiling when operating the tool.
1
NOTICE:
ing in metal or similar. It may damage the dust
cup set due to the heat produced by small metal
dust or similar.
NOTICE:
set with the drill bit installed in the tool. It may
damage the dust cup set and cause dust leak.

MAINTENANCE

CAUTION:
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Replacing filter of dust case
1. Remove the dust case while pressing down the
lever of the dust case.
► 1 . Lever
13 ENGLISH
Do not use the dust cup set when drill-
Do not install or remove the dust cup
Always be sure that the tool is
Never use gasoline, benzine, thinner,
1