Mounting On Top Of Bin - Bindicator Roto-Bin-Dicator Installation & Operation Manual

installation for use with mounting plates
1. On a 7 in. bolt circle, drill and tap or drill 6 equally spaced holes in the bin wall for 1/4 in. bolts or cap
screws. If not tapped, bolt heads should be tack welded to the bin inner wall.
2. Cut a 5 in. diameter hole to pass the paddle through. Contact factory for non-standard wall thickness
greater than 1/4 in.
MOUTING - SIDE OF BIN
1. Conduit opening must face down.
2. Assemble gasket between the mounting plate and the bin wall.
3. Flat washer, customer supplied, is recommended between mounting plate and fastening hardware.
Mounting Plate & Gasket Diagram
H-20 gasket
Mounting Plate
1 / " NDT
1
4
MOUNTING - TOP OF BIN
1. Assemble gasket between the mounting plate and the bin.
2. Flat washer, customer supplied, is recommended between mounting plate and fastening hardware.
NOTE: All extended units should have shaft guard and/or flex coupling.
NOTE: Extended units with shaft lengths greater than 12 inches require a shaft guard.
NOTE: It is recommended that the shaft guard be braced to bin will at 6 foot intervals.
installation for use without mounting plates
Preferred mount is through half couplings; a full coupling will allow material to collect around the shaft, which
may cause additional drag on the rotating shaft.
LAR180212 Rev. E
8.0" O.D.
6.0" I.D.
5
www.bindicator.com