SCA 585722 Instruction Manual page 8

INSTALLATION Cont...
STEP 4. Connect Video Extension Cable
Connect one end of the video extension RCA
cable to the RCA socket from the camera power
harness, then run the RCA cable to the front under
side of the driver side dash board to connect to
Monitors video input RCA (Yellow AV1).
NOTE: There may be multiple video inputs for
different monitors. (ie AV1 or AV2). When using
both inputs, when triggerred AV1 becomes priority.
To do this you may need to remove the rear seat
and or floor scuff panels to run the extension cable
along the side of the vehicle. The RCA cable will
be hidden when you replace the scuff panels.
STEP 5. Connect Camera Power Harness
Connect the RED wire of the camera power
harness to the wire that supplies power to the
reversing lamp (the wire that is powered only when
the car is put into reverse). Before making the
electrical connection, temporarily disconnect the
camera harness from the power plug whilst making
the connection to the reversing lamp. Use a
suitable splicing/crimp connector (scotch lock type)
or strip connector. This connection can also be
soldered, making sure to insulate the joint with
electrical insulation when done. The camera power
harness has two wires to connect (positive (+) to
reverse lamp and (-) to chassis.
8