SCA 585722 Instruction Manual page 7

INSTALLATION Cont...
STEP 3. Connect Monitor Power Harness
Recommended Power Connection: The end of
the monitor power harness cable connects to the
red power input cable connector. This connection
splits into two wires, a red and a black wire.
Connect the red wire (+12V) to a wire that is
powered when the vehicles accessories or ignition
is turned on. Connect the black wire, using a
suitable ring terminal to vehicle chassis.
Alternative Power Connection: The monitor can
also be powered from the reverse light in the
vehicle. Connect the red wire (+12V) from the red
power input cable connector to the red wire on the
RCA video lead at the display monitor end of the
cable. At the camera end of the cable, connect the
red wire to positive (+12V) at the reverse light in
the vehicle. Connect the black wire from the
monitor harness, using a suitable ring terminal to
vehicle chassis.
NOTE: if you power the monitor with this method,
the start up screen on the display will appear
everytime you select reverse, which will delay the
reverse image from appearing.
7